Bottle Opener for DIY Craft and Handmade by North Star Knife and Ulu (Square Opener (4ct))

Description

I am a craftsman that lives in Fairbanks Alaska, I make openers and bottle stoppers from antler and wood. I would love to see photos of your creations in the feedback! Also, I am happy to help you work through any installation questions and make recommendations. Here are my top installation TIPS: 1.NOT TOO TIGHT! If your bore hole is too tight the epoxy can’t do a good job. My rule of thumb is that if you can’t turn the opener into the hole by hand then it is TOO TIGHT! 2.EPOXY Matters: Don’t cut corners with the epoxy and use a fast cure solution. I recommend System Three T-88 which cures slowly and holds well 3.USE TAPE: If you tape off the head of your opener before installation you can keep it clean from epoxy residue and free of scratches. Good Luck, Nate

Plated Alloy Bottle Opener is Super Strong and Super Easy to Install (Set of 4)
Dimensions: 1.5″ wide and 3.25″ long
See my installation tips in the description below!
Easy to install threaded end Great for DIY and Craft Projects
Bore Hole Recommendation: Soft Materials 7/64″ bit and Hard Materials 1/4″ bit